Freecad

Thank God for the tutorial because the first object was not super hard to create with it. Especially since professor von Hollen went through the tutorial about a thousand times during class. I only had to redo it a few times. With von Hollen repeating the shape so many times the instructions were ingrained in my mind. Thank you!

• 

• 

For the second object, it was not as easy as the first object because I didn’t use a tutorial. But for my charger holder I decided to do a round shape thingy with a hole shaped like a line in the middle to fit the cable. I made the circle thingy a good size and dimension. I made the smallest gap in the circle about the diameter of my cable so it would fit. In order to stay on the desk I just imagined the material to be made out of rubber so it’s hard to move around😁.

• 

• 

I really had to put some creativity into how to make the third object. I thought of puzzle-like shapes that would fit inside each other. I made a box and cut a hole into it and measured the distances of the hole and used the same distances in the T- shaped object so it would fit perfectly into the hole. Since the measurements are identical then the object shouldn’t slip out from each other.